Vintage 1970-78 Camaro Specifications download pdf (Page 10)

905070 REV A , 1970-78 CAMARO w/ AC GEN IV EVAP INSTR PG 10 OF 10/3/07 27

FIGURE 10a

FIGURE 10b

KICK PANEL CAP INSTALLATION

CLOSE FRESH AIR DOOR ASSEMBLY IN KICK PANEL AND SEAL DOOR w/ 1/4” BEAD OF SILICONE AROUND DOOR

AS SHOWN IN FIGURE 10a BELOW.

INSTALL KICK PANEL CAP USING (5) #10 x 1” PAN HEAD SCREWS AS SHOWN IN FIGURE 10b.

(5) #10 x 1”

PAN HEAD

SCREWS

KICK PANEL

CAP

FRESH AIR

DOOR

1/4”

BEAD

SILICONE

EVAPORATOR INSTALLATION

ON A WORK BENCH, INSTALL EVAPORATOR REAR BRACKET AND HARDLINES WITH PROPERLY LUBRICATED O-RINGS.

(SEE FIGURE 18, PAGE 14, AND FIGURES 24, PAGE 19.)

INSTALL FRONT MOUNTING BRACKET ON EVAPORATOR USING (2) 1/4-20 x 1/2” HEX BOLTS AND TIGHTEN AS

SHOWN IN FIGURE 11 BELOW.

LIFT EVAPORATOR UNIT UP UNDER THE DASHBOARD SEE FIGURE 13, PAGE 11. SECURE LOOSELY TO THE FIREWALL FROM

THE ENGINE COMPARTMENT SIDE USING A 1/4-20 NUT AND WASHER, SEE FIGURE 13, PAGE 11.

USING (2) #14 x 3/4” SHEETMETAL SCREW SECURE THE

FRONT EVAPORATOR MOUNTING BRACKET TO THE INNER

COWL. SEE FIGURE 13, PAGE 11.

VERIFY THAT EVAPORATOR UNIT IS LEVEL AND SQUARE TO

THE DASH, THEN TIGHTEN ALL MOUNTING BOLTS.

(NOTE: TIGHTEN THE BOLT ON FIREWALL FIRST, THEN THE

FRONT MOUNTING BRACKET SCREWS.)

FIREWALL COVER INSTALLATION

APPLY A 1/4” BEAD OF SILICONE AROUND THE BACK SIDE OF THE FIREWALL COVER AS SHOWN IN

FIGURE 12, PAGE 11.

FROM INSIDE THE CAR, INSTALL FIREWALL COVER ON FIREWALL SEE FIGURE 12, PAGE 11. FROM THE ENGINE

COMPARTMENT SECURE FIREWALL COVER TO FIREWALL USING (4) 1/4-20 x 1” HEX BOLTS WITH WASHER.

SEE FIGURE 12, PAGE 11

(2)1/4-20 x ½”

HEX BOLT

FIGURE 11

1970-78 CHEVY CAMARO w/ AC GEN IV

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 26 27

No comments

Vintage 1970-78 Camaro Specifications Page 10