Vintage 1970-78 Camaro Specifications download pdf (Page 6)

905070 REV B 7/13/10, 1970-78 CAMARO w/ AC EVAP INST PG 6 OF 27

BEFORE STARTING THE INSTALLATION, CHECK THE FUNCTION

OF THE VEHICLE (HORN, LIGHTS,ETC.) FOR PROPER OPERATIONS.

STUDY THE INSTRUCTIONS, ILLUSTRATIONS, & DIAGRAMS.

ENGINE COMPARTMENT

FIGURE 1

BATTERY AND BATTERY TRAY (RETAIN). SEE FIGURE 1 AND 3.

DRAIN RADIATOR

EVACUATE THE A/C SYSTEM IF NECESSARY.

CONDENSER, LINES AND THE (4) OEM RUBBER WELL NUTS IN CORE SUPPORT (DISCARD). SEE FIGURE 1.

OEM COMPRESSOR AND BRACKET (DISCARD). SEE FIGURE 2.

EVAPORATOR AND BLOWER ASSEMBLY (DISCARD). TO REMOVE THE EVAPORATOR AND BLOWER

ASSEMBLY (UNDER HOOD) AND THE AIR DISTRIBUTION SYSTEM (UNDER DASH),THE FACTORY MANUAL

INDICATES DOING THE FOLLOWING: "REMOVE RIGHT LOWER ROCKER MOLDING.REMOVE LOWER

FENDER ATTACHING BOLTS. REMOVE SKIRT TO FENDER AND SKIRT TOREINFORCEMENT SCREWS.

PULL OUT ON LOWER PORTION OF FENDER, MOVING THE SKIRT AWAY FROM THE FENDER

FLANGE AND FIREWALL. BLOCK THE SKIRT WITH A 2 x 4 BLOCK OF WOOD".* TO AVOID DAMAGE

TO PAINT AND SHEET METAL, AND FOR EASE OF REMOVAL AND REPLACEMENT OF COMPONENTS; VINTAGE

AIR SUGGESTS THAT THE RIGHT FENDER BE REMOVED AND INNER PANEL BE LOWERED. SEE FIGURE 3.

OEM HEATER HOSES, A/C HOSES, HARDLINES AND DRIER (DISCARD). SEE FIGURE 4.

REMOVE OEM A/C & HEATER WIRING/VACUUM HARNESS MOLDED GROMMET. SEE FIGURE 4.

INSTALL 1½ PLUG IN FIREWALL

SEE FIGURE 4a BELOW.

BATTERY

CONDENSER

AND LINES

(4) OEM RUBBER

WELL NUTS

TYPICAL CONDENSER SHOWN

TYPICAL V8 SHOWN

TYPICAL HOSES

& LINES SHOWN

OEM COMPRESSOR

AND BRACKET

PASSENGER

FENDER

BATTERY

TRAY

INNER

FENDER

PANEL

DRIER

ASSEMBLY

A/C HOSES

HEATER

HOSES

BLOWER &

EVAPORATOR

ASSEMBLY

FIGURE 1

FIGURE 3

FIGURE 4

FIGURE 2

CONDENSER ASSEMBLY & INSTALLATION

REFER TO SEPARATE INSTRUCTIONS INCLUDED WITH

THE CONDENSER KIT TO INSTALL THE CONDENSER.

BINARY SWITCH INSTALLATION ( REFER TO CONDENSER INSTRUCTIONS)

REFER TO SEPARATE INSTRUCTIONS INCLUDED WITH THE

BRACKET KIT TO INSTALL THE COMPRESSOR BRACKET.

COMPRESSOR & BRACKETS

IN MOST INSTANCES THE BELT LENGTHS WILL REMAIN THE SAME.

PULLEYS

REMOVE THE FOLLOWING:

OEM A/C

& HEATER

WIRING/VACUUM

HARNESS

MOLDED GROMMET

33173-VUI

1 ½” PLUG

FIGURE 4a

1 2 3 4 5 6 7 8 9 10 11 ... 26 27

Comments to this Manuals

No comments

Vintage 1970-78 Camaro Specifications Page 6

Comments to this Manuals

Related products and manuals for Cars Vintage 1970-78 Camaro